MBRP S5082 - Manual (Page 3)

S5082 © 09/13 PAGE 3 OF 4
2. Slide the 3” Hanger Clamp onto the rear of the Extension Pipe and into
the existing rubber insulator. Refer to Figure 5.
3. Install the Mid Pipe using a 3” Clamp if required (Crew Cab 6’4”
Box).
4. Install Muffler onto the Extension Pipe or Mid Pipe using the 3”
Clamp. Refer to Figure 6.
5. Slide two 2 1/2” Clamps onto the rear of the Muffler. Feed the
Passenger Side Over Axle Pipe & the Driver Side Over Axle Pipe into the
rear of the Muffler. Install the hangers on the Over Axle Pipes onto the
factory rubber insulators. Refer to Figure 7.
6. Using the fasteners provided attach the Hanger Assembly to the bottom
of the frame. The hole is located just in front of the factory trailer hitch
bracket. Refer to Figure 8.
7. Install the Driver Side Tail Pipe hanger into the insulator on the Hanger
Assembly. Secure it to the Driver Side Over Axle Pipe using a 2.5”
Clamp. Refer to Figure 9.
Figure 6
Figure 7
Figure 8
Figure 9