Paragon 7205110 (230V) 5 COTTON CANDY - Manual (Page 6)

TROUBLESHOOTING
1. Bad vibration.
• Check to make sure there are no sugar lumps in the spinning head
2. Motor does not operate, but heater is operating.
• Motor protection has tripped off. Wait one minute and re-start.
3. Floss is being formed with clumps of sugar or floss is forming, but being cut.
• HEAT CONTROL is set at too high a setting.
4. Head is full of sugar but no floss comes out.
• Check the settings of HEAT switch and HEAT CONTROL
• Empty head and follow routine cleaning instructions.
CLEANING PROCEDURES
ROUTINE CLEANING
1. Be sure the MOTOR and HEAT switches are in the “OFF” position (cord should also be
unplugged from the outlet).
2. Allow the Spinning head unit and heater elements to cool down to a temperature that is safe
to the touch.
3. Remove the four knurled retaining nuts on the top of the spinning head unit.
4. Remove the top from the spinning head unit by lifting it off.
5. Remove the outer ring/screen assembly by sliding it up and off the heater element.
6. The top and ring/screen assembly can be cleaned by immersing in hot water and mild
detergent.
7. The heater element and head apron are now accessible for removing the sugar residue by
manual cleaning.
8. Re-assemble by installing the outer ring/screen and top. Secure with the four knurled
retaining nuts.
6