Rocky Mountain Radar Phazer-III - Manual (Page 2)

INSTALLATION
1) Attach the windshield bracket to the PHAZER 3. Align the edge
on the bracket with the slot opening on the front of the case. Slide
the bracket into the case until it locks into place.
2) Place the windshield bracket in the upper center portion of the
windshield. The ideal position will be right below the rear view
mirror. Press firmly to seat suction cups. Note: Tinted glass will
degrade the laser performance.
3) Bend the windshield bracket mount to a level position.
4) The PHAZER 3 will hang from the bottom of the bracket and
must have an unobstructed view of the road.
5) Complete and mail in the ticket rebate registration form (included
separately): A rebate will not be processed without registration.
Remote mounting is not recommended.
Hard wire: Remove cigarette lighter plug. Connect the red wire to
+12 Volts, and then connect the white wire to ground. If your power
cord has a dashed white
stripe then connect this white stripe wire to
ground and solid black wire to +12 Volts.
Rocky Mountain Radar does not condone the use of excessive
speed on the highways, nor does it endorse breaking the speed
limit laws of the United States of America. Please drive safely
when using this or any other electronic product in your vehicle.
OPERATING INSTRUCTIONS
Plug the power cord into either one of the two power jacks on
the PHAZER 3 and plug the large end into the cigarette
lighter. Push the power button to the on position. The
PHAZER 3 will automatically begin the dual diagnostics test.
The green power light will illuminate along with the yellow
test light, you will also hear a soft chirping tone from the
speaker. When the test is complete the green power light will
remain illuminated. Your PHAZER 3 is now operational.
Manual Test: Cycle the power off and then back on. The
PHAZER 3 will start the dual diagnostics test as described
above. If the power and test lights do not illuminate or no
sound is heard, check the fuse in the power cord. Replace the
two ampere fuse by removing the silver tip on the large end of
the power cord. Should you need service, return the unit to us
freight prepaid with your shipping address, phone number,
and proof of purchase.
Accessory jack: The accessory jack will power most 12-volt
radar detectors using a jumper cord.
WARRANTY: This unit is guaranteed by the manufacturer
against defects in workmanship and materials for 3 years from
the purchase date. If you have any difficulties with the
PHAZER 3, the unit will be repaired or replaced by the
factory at no charge.
ACCESSORIES
The following accessories and parts are available:
Windshield mount
$ 5.00
Jumper Cord $ 5.00
Power Cord $ 5.00
Suction Cups (set of 2) $ 2.00
2 amp fuses (two each) $ 2.00
Replacement Owners Manual $ 3.50
A $10.00 shipping and handling fee will be added to the total
of each order.
VISA/MC and Discover Accepted
CAUTION:
Tamper Fee: Tampering with, disassembly, or modification of
this product voids the warranty and a tamper fee of $75.00 will
be charged to repair it.
Unit is not waterproof; any liquid spilled will damage the unit
and VOID the warranty.
WE DO NOT ACCEPT COD SHIPMENTS
ROCKY MOUNTAIN RADAR
6469 DONIPHAN DRIVE
EL PASO, TX 79932
(915) 587-0307
(915) 587-6408
LASER and RADAR SCRAMBLER
“You can’t catch what you can’t see”
™