Rocky Mountain Radar Phazer-II - Manual

INSTALLATION
1) Attach the windshield bracket to the PHAZER II. Align the
edge on the bracket with the slot opening on the front of the case.
Slide the bracket into the case until it locks into place.
2) Place the windshield bracket in the upper center portion of the
windshield. The ideal position will be right below the rear view
mirror. Press firmly to seat suction cups. Note: Tinted glass will
degrade the laser performance.
3) Bend the windshield bracket mount to a level position.
4) The PHAZER II
will hang from the
bottom of the bracket
and must have an
unobstructed view of
the road.
5) Complete and mail
in the ticket rebate
registration
form
(included separately):
A rebate will not be
processed
without
registration.
Remote mounting is not recommended.
Hard wire: Remove cigarette lighter plug. Connect the black
with white stripe wire to +12 Volts, and then connect the solid
black wire to ground. If your power cord has a dashed white
stripe then connect this to ground and solid black wire to +12
Volts.