Rocky Mountain Radar Phazer-II - Manual (Page 2)

OPERATING INSTRUCTIONS
Plug the power cord into either one of the two power jacks
on the PHAZER II and plug the large end into the
cigarette lighter. Push the power button to the on position.
The PHAZER II will automatically begin the dual
diagnostics test. The green power light will illuminate
along with the yellow test light, you will also hear a soft
chirping tone from the speaker. When the test is complete
the green power light will remain illuminated. Your
PHAZER II is now operational.
Manual Test: Cycle the power off and then back on. The
PHAZER II will start the dual diagnostics test as
described above. If the power and test lights do not
illuminate or no sound is heard, check the fuse in the power
cord. Replace the two ampere fuse by removing the silver
tip on the large end of the power cord. Should you need
service, return the unit to us freight prepaid with your
shipping address and phone number.
Accessory jack: The accessory jack will power most 12-
volt radar detectors using a jumper cord.
WARRANTY:
This unit is guaranteed by the
manufacturer against defects in workmanship and materials
for 3 years from the purchase date. If you have any
difficulties with the PHAZER II, the unit will be repaired
or replaced by the factory at no charge.