Scrambler activation, Scrambler operation, Fig a. rmr-c430 – Rocky Mountain Radar Scrambler User Manual
Page 3: Fig b. rmr-c450
SCRAMBLER ACTIVATION:
All scramblers are factory set to the On position.
Unless otherwise noted.
Scrambler: To turn the scrambler on/off, review figure A
and B to determine which model you own. For figure A,
use a paper clip or other small pin to switch scrambler on
or off. The switch is located through the slot opening
according to the diagram. For figure B, Power off the unit,
press and hold the City button down while turning power
back on the unit.
If the scrambler is on the “T” LED light will be included
in the start up sequence. If the scrambler is off the “T”
LED light will not be included in the start up sequence.
The “T” LED light is the test diagnostics for the
scrambler.
SCRAMBLER OPERATION:
Drive normally. When the detector sounds an alert, take
your foot off the gas, check your speed, adjust if
necessary, and resume driving. Do not apply brakes unless
you are grossly exceeding the speed limit. The scrambler
will disable the radar long enough for you to adjust speed
safely, if necessary.
Rocky Mountain Radar does not condone the use of
excessive speed on the highways, nor does it endorse
breaking the speed limit laws of the United States of
America. Please drive safely when using this or any
other electronic product in your car.
Fig A. RMR-C430
DIM
MUTE
CI
TY
RMR-C450
SCRAMBLER ON/OFF: POWER OFF THE UNIT.
PRESS AND HOLD THE CITY BUTTON DOWN
WHILE TURNING POWER BACK ON UNIT.
CITY
VOLUME ON/OFF
THUMBWHEEL
P X
C 2 3 4 T
/
WHEN SCRAMBLER SWITCH IS ACTIVATED
THE SCRAMBLER TEST WILL BE INLCLUDED
IN THE START UP SEQUENCE
Fig B. RMR-C450
3