SIGMA ROX 5.0 - Manual (Page 10)

attaching the bracket
attaching the roX 5.0 and initial use
Page 10
roX 5.0
www.sigmasport.com roX 5.0
2 Attaching the ROX 5.0 and initial use
Note
see the quick start guide provided for detailed set-up instructions.
2.1 Attaching the bracket
− attachment to the handlebars or stem
− remove the yellow foil from the bracket (permanent attachment)
− the bracket can be attached using either cable ties (permanent attachment)
or the o-rings.
see attachment figures 1.1 1.2 1.3 1.4
2.2 Attaching the transmitter – speed and cadence
− Both transmitters can be attached using either cable ties (permanent
attachment) or the o-rings.
see attachment figures 2.1 3.1
2.3 Attaching the magnets – speed and cadence
see attachment figures 2.3 3.2
2.4 Putting on the chest belt
− rub the electrodes with water or cardio gel.
see attachment figures 4.1 4.2 4.3 4.4
2.5 Setting up a 2nd bike
− cautIon:
to switch the sts speed transmitter to ‘bike 2’, please use a pen to press in
the button on the back of the transmitter for five seconds until the red led
flashes (red led: bike 2; green led: bike 1).
see attachment figure 6.1
2.6 Attaching the SigmA ROX 5.0 to the bracket
see attachment figure 6.2