SIGMA ROX 5.0 - Manual (Page 32)

troubleshooting
Important information, troubleshooting, and FaQ
Page 32
roX 5.0
www.sigmasport.com roX 5.0
7.2 Troubleshooting
No speed displayed
− Is the computer correctly fastened into the bracket?
− Have you checked the contacts for oxidation/corrosion?
− Have you checked the distance between the magnet and the sts speed
transmitter (max. 12 mm)?
− Have you checked whether the magnet is magnetized?
− Have you checked the speed transmitter’s battery status?
No cadence displayed
− Have you checked the distance between the magnet and the cadence
transmitter (max. 12 mm)?
− Have you checked whether the magnet is magnetized?
− Have you checked the cadence transmitter’s battery status?
No heart rate displayed
− are the electrodes damp enough?
− Is the chest belt correctly positioned against your body?
− Have you checked the heart rate transmitter’s battery status?
Display blank
− Have you checked the roX 5.0’s battery status?
− Has the battery been correctly inserted (+ up)?
− are the battery contacts okay (bend carefully)?
Display weak/slow
− Is the temperature too high (> 60°c) or too low (< 0°c)?
incorrect speed displayed
− Have two magnets been attached?
− Is the magnet correctly positioned (parallel and centrally to the speed
transmitter)?
− Is the wheel size correctly set?
No synchronization
− Have you checked the distance between the magnet and the sensor(s)?
− Is/are the battery/batteries in the sensor(s) dead?
− Have you checked the transmitter’s range?
− If you are using a hub dynamo, please change the transmitter’s position.