Speedtech 70-81 Camaro Track Time Suspension - Manual (Page 2)

2 | P a g e
The following instructions are intended for professional installers
and are guidelines only.
Speedtech Performance assumes NO
responsibility for the installation of any of its products. All products are
intended for off road use only and must be installed by qualified
professionals only
Thank you for purchasing your new Speedtech Track Time Package. Installing
this product will require the unbolting and removal of your front suspension. Take
all necessary precautions whenever jacking up your vehicle and use safe and
sturdy jack stands to support the vehicle whenever it is off the ground. Be sure to
take all other safety precautions required to do the job correctly.
Before you get started please note that there will be some modification to your
subframe. This may be a convenient time to remove the entire frame. Doing so
will allow easier access to make the modifications, and then you can clean/
sandblast and have it painted or powder coated. If you do not already have them,
Speedtech Solid Body Mounts, part #220508, are a great compliment to this
package.
Also note that these instructions are limited to the installation processes that are
not contained in the instructions for each individual part. See the instructions
found with the individual parts for those not listed here.
Torque Specs

Upper shock mount 40 ftlbs

Lower T bar shock mounting nuts 40 ftlbs

Lower control arm nuts 40 ftlbs

Lower ball joint 50 ftlbs then to the next slot for the cotter pin

Upper control arm nuts 40 ftlbs

Upper ball joint nut 35 ftlbs then to the next slot for the cotter pin

Steering box bolts 50 ft lbs

Pitman arm nut 90 ftlbs with lock washer

½
” Tie rod end nuts 35 ftlbs then to the next slot for the cotter pin