Sper Scientific 840079 Multimeter with True RMS - Manual

Model 840079 (UT60E): Software Installation & Instructions
1
A. System Requirements
To use UT60E Interface Program, you need the following hardware and software:
An IBM PC or equivalent computer with 80486 or higher processor and 600 x 800 pixel or better monitor.
Microsoft Windows 95 or above.
At least 8MB of RAM.
At least 8MB free space in hard drive.
Can access to a local or a network CD-ROM.
A free serial port.
A mouse or other pointing device supported by Windows.
B. Installing UT60E Interface Program
The software should self-install or you may use the following instructions:
1.
-Insert the provided CD-ROM into CD-ROM drive.
-Double-click the My Computer icon from the Windows desktop.
-Locate the CD-ROM drive from the window, double-click the drive letter to display the contents.
-Double-click the file Setup.Exe.
2. Follow the on-screen installation instructions.
3. By default, the installation program will create a UT60E Interface Program folder.
C. Getting Started with
UT60E Interface Program
To run the UT60E Interface Program, please do the followings:
1. Insert the supplied RS232C Interface Cable into the slot at the back of the meter and properly connect the other end of
the cable to the serial port of computer as shown on below figure 1.
(figure 1)
2. From the Windows Start menu, choose Programs > UT60E Interface Program > UT60E
3. Press COMSetup to select corresponding COM 1/ 2 / 3 / 4.
4. Press Connect from menu bar to start the connection, the icon will be displayed.
Below is the full screen of the software shown on the computer (see figure 2):