Nilfisk-ALTO ALTO Q - Manual (Page 6)

5 5
You can control the amount of the audio signal fed into your -Q via this control. The range goes from -15dB LTO
to +15dB.
5.The INPUT control
The level boost or attenuation is set with this control. The adjusting range goes from -15dB to +15dB.
8.The LEVEL control
This control adjusts the width and can be set from a minimum of 0.03 octaves to a maximum of 1.6 octaves.
9.The BANDWIDHT control
This control set the center frequency point of the filter.
10.The FREQUENCY control
11.IN/OUT switch
It activates/disactivates the correspondent band.
3.2 The Rear Panel
12.Voltage Selector and Fuse Holder
You must be sure of the Voltage available in your Country because this is a Dual Voltage Unit. Voltage operation
can be changed through the fuse protecting the power supply but this operation must be performed by a qualified
Engineer.
6.The HIGH CUT control
This control, when activated will cut the high frequencies with a slope of 12dB per octave in a range of 2.5 kHz to
30 kHz. So if you set this control at the maximum position of 30 kHz, the audio signal will pass through without
alteration.
7.The LOW CUT control
This control, when activated will cut the low frequencies with a slope of 12dB per octave in a range of 10 Hz to
400 Hz. So if you set this control at the minimum position of 10 Hz, the audio signal will pass through without
alteration.
12
13 15 14
110-120V
220-240V
THIS IS SET FOR
110V AC TO 120V
AC OPERATION
THIS IS SET FOR
220V AC TO 240V
AC OPERATION
220-240V
110-120V
Please note the triangular markers on both sides of the fuse holder (See figure above), To change the voltage pull
the fuse holder out, rotate it 180 and push it back again. The operating voltage will be indicated by one of the two
triangular markers.
OUTPUT INPUT
TIP / PIN 2
RING / PIN3
SLEEVE / PIN 1 TIP / PIN 2
RING / PIN3
SLEEVE / PIN 1 110-120V
220-240V
2 1 3
NEW TIDE
2 1 3
NEW TIDE
AC INPUT
95-120V /210-240V 60-50Hz
Rated Power Consumption 9W
FUSE:
210-240V: T200mAL 250VAC
95-120V: T315mA 250VAC
REPLACE FUSE WITH CORRECT TYPE ONLY
Apparaten skall anslutas till
jordat uttag nar den ansluts
till ett natverk
A101