Nilfisk-ALTO ALTO Q - Manual (Page 7)

13.AC Inlet
After the correct voltage has been set you can connect the AC plug to the unit and in the AC power socket.
14.Input Connectors
Both XLR and 1/4" TRS jack input connectors are supplied in your -Q for maximum flexibility. LTO
15.Output Connector
Both XLR and 1/4" TRS jack output connectors are supplied in your -Q for maximum flexibility. LTO
4. INSTALLATION & CONNECTION
4.1 Mains Connection
4.2 Audio Connection
- Wiring Configuration
6
- In Line Connection
A Main AC cable that meets all the international safety regulations is supplied with your -Q. Please make LTO
sure of the supply voltage available in your Country before plugging in the power cord into the AC socket.
Both XLR and 1/4" TRS connectors are available on your -Q. In this way you can interface your -Q in LTO LTO
several different ways without experiencing any noise or signal loss. You can use your -Q with single instruments LTO
using the mixers main insert or on the complete mix connecting the -Q in between the mixer and the power amp- LTO
lifier.
Either the 1/4" TRS phone jack or the XLR connector can be wired in balanced and unbalanced modes, which will
be determined by the actual application status, please wire your system as the following wiring examples:
For these applications the 5-Band Parametric Equalizer provides 1/4" TRS connectors and XLR connectors to
easily interface with most any professional audio device. Follow the configuration examples below for your parti-
cular connection.
For 1/4" Phone jack
For XLR connector
XLR Type Unbalanced XLR Type alanced B
Pin3 (-)
Pin2 (+)
Pin1 ( )
(Linked to Pin1 manually, )
Pin1 ( )
Pin2 (+)
Pin3 (-)
TS Type Unbalanced
Sleeve
Tip
+
TRS Type Balanced
Tip
Ring
Sleeve
+
-
TRS Type Unbalanced
Tip
Ring
Sleeve
+