SUPERTOOTH BUDDY User Manual
Page 4
4
1. Connect the charger’s plug to the
Charger Port (10) of the
SUPERTOOTH BUDDY. Connect the charger to an external power
source.
Charge Indicator (4) Status:
Steady Red:
Battery Low
Steady Orange:
Charging
Steady Green:
Battery Full
2. When fully charged, disconnect the charger.
Pair the SUPERTOOTH BUDDY to your Bluetooth mobile phone
to create the link or audio connection between the two. The pairing
process is required only once for each phone.
Full Auto Pairing Procedure* :
IMPORTANT: Please check if your phone’s Bluetooth is enabled and
discoverable. Then place your phone and the handsfree kit close to
each other.
1. From OFF, press and hold the
On/Off (8) button of the handsfree kit
until the
Bluetooth Indicator (4) turns blinking red/blue. Then press
the
MFB (6) button to search your phone. Note: The handsfree kit
will search only for 1 minute. If your phone is not found, press the
MFB (6) button again.
2. When the handsfree kit finds the phone, accept any connection or
pairing prompts on your phone. The handsfree kit is now paired
and ready to use. Note: Older phones will ask for the password/pin
code. Enter 0000 and press
OK. The handsfree kit is now paired
and ready to use.
* Only for Bluetooth 2.1 phones
D. Power On/Off
E. Pairing to your Bluetooth Mobile Phone
Power On: Press the On/Off (8) button for 1 second, the Bluetooth
Indicator (4) turns blinking blue. A beep will be heard.
Power Off: Press and hold the On/Off (8) button for 3 seconds,
until the
Bluetooth Indicator (4) turns red. A beep will
be heard.
C. Charging