Yetter 2000 Series Vertical Tillage Tool (V.T.T.) - Manual (Page 22)

22
ASSEMBLY INSTRUCTIONS
Step 22. Install the roll pin to the shank. Insert the locking collar into the coulter swivel casting. From
the bottom, fit the shank into the coulter swivel/collar assembly. Allow the coulter to swivel, turn the shank
so that the roll pin does not engage the notch in the casting. Install and tighten the set screw into the
locking collar, torque 100 ft/lb. maximum.
Step 23. Install the shank coulter assembly to the clamp kit, secure with the cotter pin and set screws.
Adjust the shank so that the cotter pin is down against the upper shank clamp casting. Tighten the set
screws, torque 100 ft./lb. maximum.