Yetter 6000-006 Quick Response Shoe Assembly - 7200/7300 (MEII), 1700 (MEII Plus, MEII Pro) - Manual (Page 2)

Securely fasten the 6000-250 shoe to the 6000-251 arm using two 3/8” x 1-1/2” bolts, washers and
locknuts.
9. Replace blade, bearing washer, nut and cap. NOTE: the 6000-250 shoe should rub the blade and
blades should turn with some resistance, if the blades have difficulty turning the are most likely worn
too small and should be replaced.
10. Remove the two 3/8” x 2-1/2” mounting bolts for the 6000-251 arm to the row unit.
11. Install the scrapers (disregard the tension spring, it will not be used.) using the two 3/8” x 2-1/2” bolts
and lock nuts. NOTE: Use shims as necessary between the scraper arm and the row unit to apply
correct tension on the scrapers. Over tightening scrapers may prevent opener disks from turning
properly and or may cause premature scraper wear.
12. Install the depth stop adjustment assembly.
13. Install the gauge wheel arm assemblies and adjust to prevent a buildup of dirt or residue between
gauge wheels and blades, be certain wheels are positioned correctly against disk blades. Gauge
wheel tires should just touch the blades, or be no more than 1/16” away from blades at their closest
point.
14.
Adjust fertilizer shoe depth by loosening the rear 3/8” x 1-1/2” bolt, raise the shoe for a more shallow
fertilizer placement or lower the shoe for deeper fertilizer placement. IMPORTANT: It is best to
consult the fertilizer supplier for optimum placement when placing starter fertilizer in close proximity to
the seed. NOTE: If there is a buildup of damp soil the planter gauge wheels or opener disks, then
conditions are less than “ideal” and some problems may also be encountered with the Quick
Response Shoe. In some situations it may be advisable to remove the Quick Response Shoe from
the planter unit, if the problem continues.
2565-718 10/03 Great River Printing, Hamilton, IL