Yetter 6150 Series Markers - Manual (Page 8)

8
MARKER DISC ASSEMBLY
1. Assemble the marker disc assembly to the hub and bearing assembly, using a 5/16 x 1-1/4” carriage
bolts and locknuts then tighten.
2. Assemble hub and bearing assembly to the marker disc bracket using D-Bolt, 5/8” nut and lock washer
then tighten. Torque 150 ft./lbs.
3. Loosen the two 1/2” bolts on the outer end of the marker slide tube and adjust the marker disc brackets
to desired angle and retighten.
4. Fill hub and bearing assembly with general-purpose grease.
OPTIONAL
6100-334 – MARKER WEIGHT