Anthem M1 - Manual (Page 13)

12
2.3 ON MODES
With the three-way switch located on the rear panel, you can set the way the amplifier is turned on and off. To use Trigger-On, connect a standard
3.5mm (.125”) mono mini plug cable between the amplifier and the preamplifier or control component. Once all other connections are made,
connect the power cord to the amplifier and then the wall outlet.
Manual-On:
When in this position, the amplifier is turned on/off via the power button on the front panel.
Trigger-On:
This feature allows the amplifier to be turned on or off remotely via the trigger. The 3.5mm (.125”) mini-jack IN receives
power (5-24 volts DC) from an upstream component or system controller. The same trigger signal can be linked to trigger
inputs on other units through the OUT jack. When using Trigger mode, leave the front power button in the “on” position.
Auto-On:
This feature also eliminates the need to manually operate the power button. Auto-On turns the amplifier on when it senses an input signal, and
switches off 20 minutes after input signal stops. The power button on the front panel must be left “on”.
2. CONNECTIONS AND OPERATION
(continued)