DAVIS Fan-Aspirated Radiation Shield - Manual (Page 11)

Routing the Sensor and Power Cables Page 11
Solar Cable Routing
Note: You may want to test the sensor or probe before you mount the radiation shield. Please consult your
sensor, or probe installation manual to find out how to conduct the test.
To test the pre-installed Davis sensor:
1. Attach the sensor cable to the appropriate connector on the junction
box/sensor interface module (SIM).
Consult the weather station manual or installation manual for more infor-
mation.
2. Press the appropriate key on your console as necessary to make sure you
are getting an outside air temperature reading on the console.
3. If you are using a Temp/Hum sensor, press the appropriate key on your
console as necessary to make sure you are getting an outside humidity
reading on your weather station console.
4. Once you complete this test, you are ready to reassemble the radiation
shield.
#4 x 1/2" Screw
#4 Flat Washer
Cable Clamp
Motor
Fan Plate
Junction
Board
Batter
y
Batter
y
Battery
Wires
Sensor Cable
Solar Panel
Cable