DAVIS Fan-Aspirated Radiation Shield - Manual (Page 12)

Page 12 Fan-Aspirated Radiation Shield
Reassembling the Radiation Shield
To reassemble the radiation shield, do the following:
1. Make sure the sensor cable runs through the provided cable channels and
that the fan unit is seated on the fan plate.
2. Slide the two sections partially together, leaving enough clearance so that
you have access to the Junction Board.
3. Check the Junction Board cable connections for the motor and for either the
solar power cable or the AC-power adapter cable.
4. Install the Junction Board Cover as shown below. The Junction Board Cover
presses easily into place when you are installing it. To remove the cover,
press gently in on both sides to release the latches holding it in place.
Press in on Sides
near latches
to Remove Cover
Junction Board Cover
Junction Board
Junction Board Cover Installation