Acura 2010 RL - Manual (Page 401)

If there is a problem with the
starting system, you will see a
‘‘CHECK STARTING SYSTEM’’
message on the multi-information
display when the ignition switch is
turned to the ON (II) position. You
will also see this message when the
auto control mode of the starting
system has a problem.
If this message is on, the ignition
switch has to be held in the
START (III) position manually
until the engine starts. The
ignition switch can be held in that
position up to 15 seconds.
Even though you may be able to
start the engine manually without
the auto control mode of the starting
system, have your dealer inspect
your vehicle.
Starting the Engine
Check Starting System Message
398
2010 RL