AT&T 205 - Manual (Page 14)

12
Handset installation
1. Plug the handset cord into the jack on the lower side of the telephone base.
2. Plug the other end of the cord into the handset and put the handset on
the telephone base.
3. Lift the handset and listen for a dial tone. If there is no dial tone, see In
case of difficulty (page 15).
NOTES:
• You can make and answer calls as soon as the telephone is connected to a
telephone jack.
• If the handset tab on the telephone base is not reversed, the handset will
not stay in the telephone base when mounted on a wall. If you later move
this telephone to a table or desk, be sure to reverse the handset tab again.