Dee Zee DZ3030 - Manual (Page 4)

WRENCH/RATCHET
3/8", 7/16"
TAPE
13mm, 15mm MEASURE
TIN SNIPS
1/4"
DRILL BIT
Place the bulb-seal gasket [E] onto the backlip of the runing board [A]. Cut the bulb-seal gasket
with tin snips so that it is flush with the ends of the board
Loosely attach the mud flap [D] to the end of the running board using
the 1/4" x 3/4" hex head bolt [L], the 1/4" flat washer [I], and the 1/4" hex nut [J].
2
TOOLS REQUIRED
1
DZ 3027 2 OF 9 7/11/2013