Dee Zee DZ3030 - Manual (Page 6)

Use the nutsert set tool [F] to crimp the nutserts in the holes.
Hold the nut on the set tool with a 15mm wrench. Tighten the bolt in the set tool with a 13mm
socket.
Torque the nutserts to the spcification below to insure they are set correctly.
Put a 8mm x 25mm bolt [H] through the top hole in the brace [M] and thread into the
8mm threaded plate [P] until the bolt starts to come through the threaded plate.
Repeat this for the other braces.
4
5
DZ 3027 4 OF 9 7/11/2013