Dee Zee DZ2544 User Manual
Page 10
Advertising
Drill 1/4" holes up through the slots into the board at the locations shown below.
Attach the running board to the angle brace using the hex head bolt [G],
1/4" flat washer [H], and 1/4" hex nut [I]. Tighten using a 7/16" wrench and socket.
15
14
Check all hardware to make sure it has been tightened.
Repeat the assembly steps for the other side of the vehicle.
DZ 2544
8 OF 8
2/12/2013
Advertising
See also other documents in the category Dee Zee For the car:
- DZ370183 (4 pages)
- DZ370203 (3 pages)
- DZ370233 (2 pages)
- DZ370313 (3 pages)
- DZ370353 (5 pages)
- DZ370393 (4 pages)
- DZ370693 (3 pages)
- DZ371033 (4 pages)
- DZ371193 (2 pages)
- DZ371213 (4 pages)
- DZ371233 (3 pages)
- DZ371243 (3 pages)
- DZ371253 (3 pages)
- DZ371263 (4 pages)
- DZ371293 (2 pages)
- DZ372663 (4 pages)
- DZ372833 (6 pages)
- DZ371273 (2 pages)
- DZ370113 (4 pages)
- DZ370303 (4 pages)
- DZ370503 (6 pages)
- DZ370583 (4 pages)
- DZ370593 (4 pages)
- DZ370643 (4 pages)
- DZ370783 (6 pages)
- DZ371513 (5 pages)
- DZ371523 (6 pages)
- DZ371533 (4 pages)
- DZ371643 (4 pages)
- DZ371953 (3 pages)
- DZ372213 (4 pages)
- DZ372233 (4 pages)
- DZ372243 (5 pages)
- DZ372253 (4 pages)
- DZ372293 (2 pages)
- DZ372333 (5 pages)
- DZ372693 (5 pages)
- DZ371823 (4 pages)
- DZ370403 (4 pages)
- DZ370343 (4 pages)
- DZ372513 (3 pages)
- DZ372523 (4 pages)
- DZ372533 (4 pages)
- DZ370793 (5 pages)
- DZ370211 (3 pages)