Night Owl PE-DVR4 user manual - Manual (Page 51)

Chapter 15: Advanced Menu
51
15.2 Network Menu
15.2.1 LAN Menu
The LAN Menu allows you to configure the IP address for your DVR. Make
sure that the DVR is plugged directly into your internet router.
To access the LAN Menu, select the Advanced button, select Network
from the list on the left side of the screen, and then select LAN.
• The IP address/DNS server information can automatically be
obtained by the DVR if it is connected to a router/modem that is
connected to the internet. Select Obtain an IP address
automatically and Obtain DNS server address automatically.
• You can manually enter the IP address/DNS server information into
the DVR by selecting Use the following IP address and Use the
following DNS address and entering the correct information.
• IP Address: This is the identification of the DVR when it is
connected to a network.
• Subnet Mask: Describes the range of IP addresses that can be
found in the network. It should always be set to 255.255.255.000.
• Default Gateway: This is the connection between two networks.
This should be the router’s IP Address.
• Preferred DNS Server: The primary DNS (Domain Name System).
• Alternate DNS Server: The secondary DNS server.