Alpine CDA-105 - Manual (Page 44)

42
-EN
Remove the iPhone/iPod
Remove the iPhone/iPod from Interface cable for iPod
(KCU-440i, sold separately).
• After changing the unit to a source other than the iPhone/iPod,
remove the iPhone/iPod. If the iPhone/iPod is removed in the iPod
mode, data may cause damage.
• If sound is not output or the iPhone/iPod is not recognised even when
the iPhone/iPod is connected, remove the iPhone/iPod once, then
connect it again, or reset the iPod.
• Do not leave the iPhone/iPod in a vehicle for a long time. Heat and
humidity may damage the iPhone/iPod and you may not be able to
play it again.
USB memory Connection (sold separately)
Connect USB memory
Connect USB memory to USB cable.
Remove USB memory
Pull out USB memory squarely from the USB cable.
• When removing USB memory, pull it out straight.
• If sound is not output or USB memory is not recognized even when
USB memory is connected, remove USB memory once, then connect
it again.
• Change to a source other than the USB memory mode, then remove
the USB memory. If the USB memory is removed in the USB memory
mode, data may be damaged.
• Route the USB cable away from another cables, etc.
Cable (sold separately)
USB memory
(sold separately)
This unit
Lock case
(Included with cable)
This unit
USB connector
Cable (sold separately)
USB memory
(sold separately)