X Rockers 51483 - Manual (Page 4)

Answers to frequently asked questions are available at www.x-rocker.co.uk.
Use the Contact Us online form or call
+44(0)
1992 450333.
More information please see additional assembly instruction!
FUNCTIONS:
Foldable construction for ease of storage and portability.
Side control panel with volume, bass control, vibration control, input/output jacks, and band switch.
Ergonomic design with full back support.
Easy to clean heavy duty upholstery grade vinyl cover.
Wireless audio transmission.
READ BEFORE USAGE:
Always make sure hinge is locked before moving.
Always make sure hinge is locked before sitting in the chair.
Excessive use of audio equipment could lead to hearing loss.
Excessive sound pressure from earphones and headphones can cause hearing loss.
Children under the age of 13 should not use this product without adult supervision.
Strictly for indoor use. Do not expose to direct sunlight, moisture or extreme temperatures.
If the cover becomes wet, disconnect the power immediately and don’t use until it is completely dry.
Do not attempt to remove the cover or any components. Removal of the cover or tampering with components puts you
at risk for injury or death from electrical shock.
When using in wire mode, please keep the band to “OFF”
(A6).
The maximum input of the TX box is 1V. If the input is over 1V, the sound can become distorted to fuzzy .If the sound
coming out of the chair is fuzzy at low volumes,lower the volume on the audio source(ex.The TV,Mp3,etc)and the
distortion should go away.
Do not mix alkaline, standard carbon-zinc, or rechargeable Ni-cad, NiMH, etc.
Do not mix old and new batteries.
SET UP:
1. Lift X Rocker out of box.
2. Keep the chair in the folded position and place it on the floor so that back side of the chair is touching the floor and
the bottom of the seat is facing up.
3. Review the set up diagrams to familiarize yourself with the X Rocker’s components,accessories and set - up.
4. Insert pin into closure. Pull and secure the Velcro flap to hide pin and closure. please complete steps1 -
 to assemble
the chair.
5. When used in wireless mode, make sure that the control panel is not more than 65.6ft / 20 meters from the audio source
and 6.5ft / 2 meters from a power source.
6. Unpack the power adapter and connect it to the main power outlet, then to the power jack on the control panel(A8).
7. Press the power button(A7) and confirm that the power indicator light(A9) is on. In wireless mode, turn on the power to
the TX box(A14), confirm that its indicator light is on, and check that the band selected on the TX box(A15) is the same
as that selected on the control panel(A6) of the X Rocker.
8. Follow the connection diagrams. They show how to connect the X Rocker to the audio source of your choice.
9. Adjust the bass and volume levels to your preference
start rocking.