Ag Spray Equipment AG300-500RC - Manual (Page 3)

2
Pressure Head Stand
Pressure Head can be adjusted in & out, also, up & down.
loosen the T bolt on top to move closer to tractor or further
away from tractor. If it’s too low or too high, simply loosen
the T bolt on bottom side tubing & adjust as needed.
NOTE: Pressure Head stand is not included w/ electric
controls. Another bracket will be made to hold
the valves.
Bottom plate that bolts to the frame can be adjusted as well.
AA17L
How to use the 17L Tee Valve:
The 17L Tee valve has markings on the dial face L (left), C (center), & R (right). If it reads LCR this
means that the left, center, & right booms will be on. If it reads RC this means that right & center only will
be on.
IMPORTANT: The lever must be pulled up to turn booms on. Simply, flip handle back down to shut off
booms.
Adjust pressure w/ the regulator (gray knob). Set the agitation valve, brass valve on the side, to ¾ of the
way open. Do not adjust the pressure w/ this valve unless the system will not put out enough pressure.
PSI
A3434S
ON BOTTOM BACK SIDE- INLET LINE
A3412S
100 PSI LIQUID GAUGE
A3434S
23120 REGULATOR
EK34STEL
17L TEE VALVE
EK34X14BU
AM14B
A1412S
EK14CLONIP
EK14STEL
PRESSURE HEAD FOR AG 300 - 500 TR
Telescopes in & out - Adjust to your tractor
Telescopes up & down