EarthQuake Cinenova 7 - Manual (Page 11)

11
Cinénova Grande BR Bridging Feature Cinénova Grande Power Amplifiers
Bridging Cinénova Grande BR 7 Channel to 5 Channels
The Cinénova Grande BR 7 Channel has six
channels that can be bridged to create three
channels. The seventh channel is always a stereo
channel and should always be set to “MASTER”
since it has no slave.
In order to bridge the first and second channels, the
first channel must be set to “MASTER” and the
second channel must be set to “SLAVE.”
To bridge the third and fourth channels, the third
channel must be set to “MASTER” and the fourth
channel must be set to “SLAVE.”
To bridge the fifth and sixth channels, the fifth
channel must be set to “MASTER” and the sixth
channel must be set to “SLAVE.”
Applications
In the diagram to the right, a seven channel amplifier
has been bridged to create a five channel amplifier.
Though it is capable of bridging two more channels,
this bridging mode is applicable to more users.
MONO MONO MONO MASTER SLAVE MASTER SLAVE
Minimum 8-Ohm Minimum 8-Ohm
LEFT FRONT RIGHT FRONT
REAR LEFT CENTER REAR RIGHT
Minimum 4-Ohm Minimum 4-Ohm Minimum 4-Ohm
www.earthquakesound.com