EarthQuake Titan Telesto - Manual (Page 8)

Telesto Specifications
25Hz-40kHz Frequency:
94dB+/-3dB Sensitivity:
4 Ohms Nominal Impedance:
350Hz, 3.2kHz, 10kHz Crossover frequency:
100WRMS and up to 500WRMS
Recommended amplifier power:
50.5in/1282mm
7.7in/195mm
18.3in/465mm
Dimensions
Height:
Width:
Depth:
31kgs/68.3lbs Net weight:
Available finish: Fine high gloss 3mm black lacquer paint
Telesto Dimensions and Specifications
Telesto Manual 8 Telesto Manual 7 Earthquake Sound Corp. | (800) 576-7944 | www.earthquakesound.com
back view
front view
4.25”/108mm
5.7”/145mm
5.4”/138mm
50.5”/1282mm 44.7”/1
135mm
7.7”/195mm
side view
44.7”/1
135mm
1.7”/44mm
10.6”/270mm
15.9”/403mm
18.3”/465mm
1.7”/44mm
19.7”/500mm
back view top view
18.3”/465mm
Power: 500W
4 Ohm Impedance:
25Hz-40kHz Frequency Response:
88dB/1m/2.83V Sensitivity:
S/N:
EARTHQUAKE SOUND U.S.A
www.earthquakesound.com
LO
HI
Power: 500W
4 Ohm Impedance:
25Hz-40kHz Frequency Response:
88dB/1m/2.83V Sensitivity:
S/N:
EARTHQUAKE SOUND U.S.A
www.earthquakesound.com
LO
HI
Amplifier Set-up Options
Single Amp. Option
Bi-Amp. Option
The Telesto is designed to accept
two separate Amplifier/Power
Sources. For a Bi-Amplifier option,
take off gold bridging bars by
unscrewing terminals. Connect the
terminals to Amplifiers as shown
below. Be sure to tighten terminals
after bridging bars are off.
Amplifier/
Power Source
Amplifier/
Power Source
For one Amplifier/Power Source per
system or per tower, leave gold
bridging bars on. Connect to the
Amplifier/Power Source from either
the high or the low terminals.
Specifications are subject to change without notice.