Arcam AVR Surround Amplifer AV888 - Manual (Page 11)

E-9
English
Zone 3 connectors
Z3 OUT
Connect these analogue audio
outputs to your Zone 3 equipment.
See ‘Multi-room Setup’ on page 48
for information.
Zone 2 connectors
Z2 AUDIO OUT, Z2 VIDEO OUT
Connect these analogue audio
and video outputs to your
Zone 2 equipment. See ‘Multi-
room Setup’ on page 48 for
information.
��
�����
���
��
�����
���
��
���
���
���
���
���
���
����
��������� �������
� �
� ��
��
���
��
��
���
��
���
� �
��
�
��
�
��
�
���
� � �
��
�
��
��
�
��
��
�
��
��
�
��
��
�
��
��
�
��
��
���������������
S-Video and
Composite
connectors
AV, DVD, SAT, VCR, PVR
Connect these inputs to the
S-Video and Composite outputs
of your available source equipment.
VCR OUT, PVR OUT,
These are recording outputs. Connect these to the
‘S-Video in’ or ‘Composite in’ sockets (usually labelled
‘ RECoRD ’) on your recording device.
MAIN OUT
Connect this output to the S-Video or Composite
sockets on your primary Zone 1 display.
Component/RGb
video connectors
These inputs are suitable for
connection to source devices
which output Component (YUV
or YPbPr) or RGB high quality
analogue video signals. These
signals are usually available from DVD players, set-top
boxes or games consoles.
If you are connecting up to an RGB source you will
also need to connect the source’s Composite output to
the unit’s Composite input to act as a video sync. The
Composite signal should be on the same named input as
the RGB signals.
RGB video outputs on source equipment are often on
SCART connectors. You will need to use a SCART to
‘RGB+Sync on phono’ breakout cable, available from
your Arcam dealer.
NOTE
When setting up the menus (later in this manual),
you will need to select whether the three-wire high
quality video input is Component or RGB for each
input. This is done on the ‘HQ Video In’ line in the
Input Config menu. Failure to do this can result in a
green looking picture or a picture that is unstable.
AV, DVD, SAT, VCR, PVR
Connect the Component video outputs of your source
equipment to these inputs.
OUT
Connect this output to the Component video input of
your display device.
NOTE
Analogue RGB video output is not available from
the AVR600 or AV888. The analogue three-wire
high quality video output is always configured as
Component video.
����
��
��
���
���
���
���
�������
����
�����
����
� � ��
���
��
��
���
digital audio
connectors
TAPE, CD, AV, DVD, SAT, VCR, PVR
Connect these inputs to the digital
outputs of your available source
equipment.
OPTICAL, COAX
Connect the optical or coaxial output
to your digital recording device such as
CD-R, digital VCR or Minidisc player.
When a digital source is selected,
the digital output will send an exact
copy of the incoming digital signal. For example, for a
5.1 digital source, the digital output will also be in 5.1
format.
When an analogue-only source is selected, this is
digitized by the unit and routed to the digital outputs.
These outputs are muted if a source is selected where the
HDMI connection is used and is transmitting HD audio.
The digital audio from the HDMI link will not be routed
to these outputs.