Vaisala Setting up Digi Connect Wi-SP or ConnectPort TS W Devices with viewLinc - Manual (Page 10)

Page 10 of 12
V e r i t e q , a V a i s a l a c o m p a n y T e l 6 0 4 2 7 3 6 8 5 0
1 3 7 7 5 C o m m e r c e P a r k w a y 1 8 0 0 6 8 3 8 3 7 4 ( N o r t h A m e r i c a )
R i c h m o n d , B C , C a n a d a , V 6 V 2 V 4 F a x 6 0 4 2 7 3 2 8 7 4
w w w . v e r i t e q . c o m | w w w . v a i s a l a . c o m c u s t o m e r s u p p o r t @ v e r i t e q . c o m
Wireless LAN Configuration Commands
Introduction
The same commands are used for Telnet or terminal emulation communication modes.
Network configurations vary widely, so it is impossible to provide the exact set of commands you need to
enter for your particular installation. The syntax of the commands, and some sample configurations, are
provided.
For more information on the various settings, read the “WiFi LAN Settings”, “WiFi security settings”, and
“WiFi 802.1x authentication settings” sections in the Configure Digi devices chapter of the Digi Connect
Family User’s Guide document. Also refer to the description of the set wlan command in chapter 2 of the
Digi Connect Command Reference document.
Entering the Commands
Carefully enter the desired commands in the Telnet or terminal emulation window, following each by
pressing the Enter key.
You may wish to create a text file containing all the commands and settings, then copy and paste them
into the Telnet or terminal emulation window. This can eliminate typing errors and save time, especially if
more than one device is being configured. Just remember to change the IP address in the text file for
each device if using static IP addresses.
After resetting the device you may need to press the Enter key again to cause the login: prompt to be
displayed (but first wait for the device to become ready again).