HighPoint RocketRAID 1740 - Manual (Page 15)

RocketRAID 174x Hardware Description/Installation
4 - Verifying Installation
Once the RocketRAID 174x host adapter and hard disks have been installed into the
chassis, boot-up the system to verify that the hardware is properly recognized.
1. Power on the system. If the system detects the presence of the adapter, the
RocketRAID 174x BIOS Utility will be displayed during bootup.
2. Press Ctrl+H to access the RocketRAID 174x BIOS Utility.
The BIOS Utility will display information about hard disks attached to the adapter.
Make sure all attached disks are detected by this utility. If any of the hard disks are
not detected, power down the system and check the power and SATA cable
connections.
2-5