HighPoint RocketRAID 1740 - Manual (Page 28)

RocketRAID 174x Driver and Software Installation
3. Double click the “SCSI and RAID controllers” entry. If the RocketRAID 174x
device entry is not displayed, or there are “?” or “!” marks displayed near the
RocketRAID 174x entry, the driver has not been installed properly. Delete the
entries and reinstall the driver.
Installing the RocketRAID 174x driver during a fresh Windows
2000/XP/2003/x64/Vista installation
Note: Windows operating systems require driver input from a floppy disk drive – they
will not accept drivers from other media during the installation phase.
1. After booting from the Windows 2000/XP/2003 CD-ROM, when the Windows
Setup blue screen appears, look towards the bottom of the screen. Windows will
prompt you to press the F6 key if you want to install a third party SCSI or RAID
driver. Press the F6 key at this time.
2. The setup procedure will continue, and will later instruct you to press the “S” key
to specify additional adapters. Press the “S” key as instructed.
3. Next, the setup program will prompt for the insertion of the driver diskette. Please
insert the driver diskette, and then press ENTER to continue.
4. The next window will display several driver options. Please select the
RocketRAID 174x Controller for the corresponding operating system, and press
ENTER to continue.
1 Web RAID Management Interface
Note: To use the web-based RAID management interface, a web browser with XML
support is required, e.g. Internet Explorer 6.0, Mozilla or FireFox
To run the management interface, start your browser and enter the following URL
address:
https://localhost:7402
If you are managing a remote system please change “localhost” to the server’s host
name or IP address.
The default user name is “RAID” and the initial password is “hpt”. You can change
the password after you have logged in.
4-4