HighPoint RocketRAID 2210 User Manual
Page 13
RocketRAID 2210 Hardware Description/Installation
2 - LED Connections
The RocketRAID 2210 has two LED jumpers that are used to indicate the activity and
failure status of hard disks attached to the card’s four SATAII channels. These jumpers
are labeled as CONN# (connector).
The odd numbered pins of each CONN (1, 3, 5, and 7) represent the RocketRAID
2210’s SATA channels 1, 2, 3, and 4 respectively.
CONN3 - Hard Disk Failure LED’s.
3 - Installing the RocketRAID 2210 Host Adapter
Note: Make sure the system is powered-off before installing the RocketRAID 2210
host adapter.
The RocketRAID 2210 includes both standard and low-profile brackets. It may be
necessary to attach the low-profile bracket in place of the standard bracket, depend-
ing upon the chassis design.
1.
Open the system chassis and locate an unused PCI-X slot.
2.
Remove the PCI slot cover.
3.
Gently insert the RocketRAID 2210 into the PCI slot, and secure the bracket to
the system chassis.
CONN1 - Hard disk Activity LED’s.
2-2