HighPoint RocketRAID 2210 - Manual (Page 15)

RocketRAID 2210 Hardware Description/Installation
4 - Verifying Installation
Once the RocketRAID 2210 host adapter and hard disks have been installed into the
chassis, boot-up the system to verify that the hardware is properly recognized.
1. Power on the system. If the system detects the presence of the adapter, the
RocketRAID 2210 BIOS Utility should display the following prompt (screenshot).
2. Press Ctrl+H to access the RocketRAID 2210 BIOS Utility.
The BIOS Utility will display information about hard disks attached to the adapter.
Make sure all attached disks are detected by this utility. If any of the hard disks are
not detected, power down the system and check the power and SATA cable
connections.
2-4