Red Lion PMK6A - Manual

1
The panel mount adapter kit is used to mount 1/16 DIN instruments into
existing vertical or horizontal 1/8 DIN panel cut-outs. The kit includes two
black painted durable steel mounting plates and a sponge rubber gasket. The
Adapter Kit, when used with a unit which has NEMA 4/IP65 specifications,
will meet NEMA 4/IP65 requirements when properly installed. Red Lion
Controls 1/16 DIN products include Temperature and Process Control Units
(Models T48, and P48), and the C48 units.
PANEL MOUNT ADAPTER KIT - 1/8 DIN TO 1/16 DIN
DIMENSIONS In inches (mm)
INSTALLATION
TYPICAL VERTICAL MOUNT INSTALLATION
1. Remove the paper backing from the adhesive side of the
adapter gasket (included with adapter kit) and
carefully apply the gasket to the front of the existing
panel cut-out.
2. Carefully remove the center section of the
panel gasket (provided with the unit) and
discard. Slide the panel gasket over the
rear of the unit to the back of the
bezel.
3. Slide the mounting plate
over the rear of the unit
to the back of the unit bezel.
4. Insert the unit with
mounting plate into the
panel cut-out from the front.
Slide the adapter plate over
the rear of the unit. The
protrusion on the adapter
plate is designed to fit into
the existing 1/8 DIN
panel cut-out to properly
position the unit.
5. Refer to the installation
section of the manual,
supplied with the unit, to
complete the installation.
MODEL NO. DESCRIPTION PART NUMBER
PMK6 Panel Mount Adapter Kit (1/8 DIN to 1/16 DIN) PMK60000
ORDERING INFORMATION
ADAPTER PLATE
Bulletin No. PMK6/A-C
Drawing No. LP0481
Released 3/08
Tel +1 (717) 767-6511
Fax +1 (717) 764-0839
www.redlion.net
MOUNTING PLATE