ARI Armaturen STEVI 460 DN 300-500 EN - Manual (Page 3)

Rev. 0040304002 0410 Page 3
Operating and installation instructions
Str. thr. stop valves - STEVI
®
405 / 460 (DN300-500)
4.0 Description
4.1 Scope of applications
Valves are used for „interrupting the flow of liquids, gases and vapours in chemical,
processing, and other plants“.
The information complies to the Pressure Equipment Directive 97/23/EC.
It is the responsibility of the machine planner to ensure compliance.
The special markings on the valve must be taken into account.
Refer to the catalogue sheet to see which materials are used in standard versions.
Please contact the supplier or the manufacturer if you have any questions.
4.2 Operating principles
ARI stop valves are particularly suitable for operation by pneumatic or electrical actuators.
The flow direction in these stop valves must be always opposite to the closing direction.
ATTENTION !
- Refer to the data sheet for applications, limits on use and possibilities.
- Certain media require or preclude the use of special materials.
- The valves are designed for standard operating conditions. If conditions exceed
these requirements, e.g. aggressive or abrasive media, the operator should
state the higher requirements when ordering.
- Valves made from grey cast iron are not authorised for use in systems subject
to TRD 110.