Avocent KVM over IP switch - Manual (Page 29)

8/16 PS/2 KVM over IP switch
26
be flashed during the refresh process.
When the OSD value back to default setting, the bank seven segment LED on the front panel
will stop flashing
5.3 Login into the PS/2 IP-KVM switch and logout
5.3.1 Login into the PS/2 IP-KVM switch
Launch your web browser. Direct it to the address of your PS/2 IP-KVM switch, which you
configured during the installation process. The address used might be a plain IP address or a
host and domain name, in the case where you have given your PS/2 IP-KVM switch a
symbolic name in the DNS. For instance, type the following in the address line of your
browser when establishing an unsecured connection:
http://<IP address of PS/2 IP-KVM>
When using a secure connection, type in:
https://<IP address of PS/2 IP-KVM>
This will lead you to the PS/2 IP-KVM switch login page as shown in Figure 5-3.
Figure 5-3. Login screen
The PS/2 IP-KVM switch has a built-in super user that has all permissions to administrate
your PS/2 IP-KVM switch:
Login name super (factory default)
Password
pass (factory default)
Table 5-1. Standard user settings
Warning
The user “super” is not allowed to login via the serial interface of the PS/2 IP-KVM
switch.