VariZoom VZTOC-FI2 - Manual (Page 6)

- 6 -
1. Home Screen
From the Home Screen, you can monitor the current
lens positions as well as enter the setup screens for Iris
and focus. You can also enter the Control, Calibrate,
Setup, and System menu screens. From this screen tap
“Open Iris” to fully open iris. Tap the button again to
return the iris motor to the location of the iris slider.
Note:
Zoom shows on the home screen. This is built in to the
software, and requires a three channel hand unit to be
operated.
Zoom Setup Menu:
This menu is reserved for use with an optional
zoom joystick, and third motor.
3. Iris Setup Menu
From the Iris Setup screen, you can set the iris motor and
slider limits, reverse motor and slider response direction, as
well as adjust smoothing.
To set a limit, simply move the slider to the where you
want the limit, and tap the “set limit” button. Once a limit
is set, the “Set Limit” button will then read “Clear Limit”. Tap this button to clear the
limit.
Motor and slider response direction is changed by selecting the “Dir+” button located
under either “Motor” or “slider”. This will change the button to be “Dir-“. Select it
again to change it back.
Smoothing is adjusted by selecting the “set” button next to the “smooth” indicator.
Adjust the “Lens Smoothing” to the desired smoothing level, then press “OK”
Note: The
more smoothing you have, the more delay will show between motor and knob/slider
response.
Press the “ ” button in the top left corner of the screen to return to the Home Screen.