VariZoom SOLO SLIDER DOLLY KIT - Manual (Page 2)

Step 1 – Setting up the Track
1) Start by connecting the first 2 track pieces with one of the crossmembers.
2) Now add the underpads below the 2 track pieces. Continue adding track pieces and
underpads until you have the desired length.
3) Connect the final 2 track pieces with the second crossmember.
Step 2 – Setting up the Dolly
Unfold the dolly and lock it in place using the
knob at the center where the legs come
together.
Depending on the tripod, you may have to
adjust the position of the foot locks by
loosening the slide lock knobs.
Now you can place the dolly onto the track. If
the width of the track seems slightly off, you can
adjust the position of the clamps on the ends of
the crossmembers using the supplied hex key.
The clamps can move in or out slightly, thereby
adjusting the width of the track.