VariZoom SOLO SLIDER DOLLY KIT - Manual (Page 4)

You can also add a mini tripod, or hi hat, to the
Solo Slider Dolly for low angle creative shots.
Depending on your setup, you may want to add a bit of weight to add stability (as long
as you don’t exceed the 45lbs recommended payload). For example, if you’re using the
Solo Slider Dolly with a lightweight tripod and camera, you may find that it’s beneficial to
add a ‘rock bag’ like the
VZTRB so you can add some weight between the tripod legs
and lower the center of mass. This is purely a personal preference, but adding mass and
lowering the center of gravity will provide better stability and more inertia, which may
smooth out your moves.
Step 4 – Operating the Solo Slider Dolly
Operating the Solo Slider Dolly is fairly self-explanatory, but here are a few helpful notes:
-Always keep the tracks clear of debris and objects to prevent damage or derailing.
-When pushing the dolly-tripod, it’s preferable to grab and push at a lower point on the
tripod, as this will typically offer more stable operation. It’s fine to move it however you
please, but just be aware that pushing or pulling at the highest point will create the
greatest chances of wobbling or tipping.
-If the dolly sits idle on the track for a long time, the rubber wheel liners may get a bit of a
temporary flat spot. This will work itself out by rolling the dolly back and forth a few feet, or
you can also ‘pop’ them by pulling out on them in a few spots around the rim like a
rubber band.
-If the rubber wheel liners get damaged, you can replace them with the extras included.
-Take care not to push the dolly off the end of the track and over the crossmembers.
-Use GREAT CARE when operating the dolly with a mounted jib. People can be injured
and property damaged by a moving dolly-jib, even one as light as this system.