Troubleshooting – Audiovox ACAM350 User Manual
Page 8
Advertising
Troubleshooting
Symptoms Solutions
The ON/OFF signal light
<D> is not on after the car
is started
Ensure that the parallel red and black line from
the control box is connected properly.
No video signal appears
while reversing the car
1. Verify that the LCD Contrast
(Brightness) control knob is not set too
low
2. Check the rearview Camera lens.
3. Check the rearview Camera wiring and
connection.
4. Confirm that the cable from the monitor
is connected properly.
Video image is not sharp
enough
Clean the camera lens.
7
Advertising
See also other documents in the category Audiovox For the car:
- ACA200 (18 pages)
- GC-600GAB (2 pages)
- PRO 9246CH (8 pages)
- AS-RS (8 pages)
- WFM7810 (3 pages)
- Automobile Accessories (20 pages)
- PRO 9232 (8 pages)
- PRO-OE3C (4 pages)
- CMOS2 (2 pages)
- APS-55TWT (4 pages)
- Prestige APS-25HJ (12 pages)
- APS 996 (28 pages)
- PRO-9056 (19 pages)
- APS 95 BT3 (12 pages)
- PRESTIGE PLATINUM BY AUDIOVOX APS 686T (20 pages)
- PRO 9232S (8 pages)
- 50-0312x SERIES (5 pages)
- PRO-9056TW (2 pages)
- ACAM250 (10 pages)
- AS9233ST (8 pages)
- AX-45 (8 pages)
- AA-RS5CS (16 pages)
- PRO 9445FT (4 pages)
- PRO 2000 (2 pages)
- APS-25KB (6 pages)
- AS-9501a (2 pages)
- 50-0301x-014 SERIES (5 pages)
- Prestige 128-8601 (8 pages)
- APS-92BT-CL (6 pages)
- ROSIBC (5 pages)
- APS 800a (8 pages)
- Prestige 128-8602 (8 pages)
- 50-0286x-019 Series (6 pages)
- CMOLF (8 pages)
- APS-800 (12 pages)
- 5BCR (8 pages)
- AS-GMDLT03 (2 pages)
- CAMSBAR (14 pages)
- AS-9631 (1 page)
- CA 5150 (10 pages)
- CCDLF (8 pages)
- Platinum APS 675 (18 pages)
- SPS GC-600 (2 pages)
- PRO 9549FT3 (8 pages)