Dake Model G-75 - Manual (Page 7)

5/20/2010
Model G-75 7
components are broken or missing. Replace any worn or broken parts without delay.
6. Do make sure the incoming power supply is up to codes and kept in good condition.
7. Do always wait until belt has stopped completely before opening covers / doors,
reaching into point of operation or making adjustments.
8. Do use good quality belts of the right size. Change belts when needed. If the belts
are worn, burnt, frayed or cut they must be changed.
9. Do use the tool rest or angle guide when grinding. Do not free hand.
10. Do keep hands away from the belt and parts of material being ground. The hot parts
can burn you.
11. Do keep all work surfaces and spark catch box clean.
12. Do adjust the machine for a comfortable work height.
13. Do keep area of machine well lit.
14. Do keep all visitors and children a safe distance from machine.
15. Do anchor the machine to a solid level floor.
16. Do not wear loose clothing, jewelry, neck ties, rings, loose long hair, gloves, or
clothing that will burn easily.
17. Do not force the work. Too much pressure or hard jabs can cause injury, ruin the
belt, create excessive heat.
18. Do not use grinder if persons are close to the exhaust end of the machine.
19. Do not operate machine if the spark catch box is not installed. Fire Hazard!
20. Do not operate the machine if under the influence of drugs, alcohol, or medications.
21. Do not use machine for purposes that it was not intended for. Do not force the
material.
22. Do not leave the machine running unattended. Always turn off machine and wait for
it to stop before walking away.
3. Operation of the machine:
3.1 Adjusting the machine for comfortable height.
1. Loosen the head tilt lock bolt on the pivoting point of the base. Do not loosen too much
that the grinding head tilts too freely. With this bolt loosened tilt the grinding head up or
down to suit your needs. Securely tighten this bolt. (Figure 12)
Figure 12