AquaStar Starztruck Automatic Suction Pool Cleaner - Manual (Page 8)

6
Observe your StarzTruck automatic pool cleaner in operation at higher speed with dual or variable speed
pumps. Adjust the regulator, three-way or ball valves to speed up or slow down the cleaner (see Fig. 9). When
the StarzTruck automatic pool cleaner seems to be spending too much time against steps, vertical walls and
other obstructions, turn the rear flap tension adjuster to position I (see Fig. 10). The rear flap adjuster is preset
to II. Sometimes adjusting your flow valve up or down will help. Nevertheless, custom pools with interior bar
stools, fountains, planters, etc., will require someone to physically free the cleaner from its entrapment.
The StarzTruck automatic pool cleaner will climb vertical walls in concrete and fiberglass pools (not vinyl)
if there is at least a 12-inch radius where the floor meets the walls. Because of the internal programmed gear
box, the cleaner will not climb the wall every time. Likewise, it will not always go all the way up the wall.
If the StarzTruck automatic pool cleaner is not sticking to the wall, set the rear flap to position III (see Fig. 9)
and/or adjust your regulator valve(s). If the cleaner climbs above the waterline and sucks air, set the rear flap
to position I (see Fig. 10) and/or adjust your regulator valve(s).
step 3: adjustinG Your starztruck automatic pool cleaner continued
Fig. 10
Rear flap tension adjuster
Fig. 9
Screw top in.
Bypass less water.
Speed cleaner up.
Unscrew top.
Bypass more water.
Slow cleaner down.
Max
Max
Min