Kenwood PKT-23K - Manual (Page 2)

Options
ADS#40013 Printed in USA
Specifications shown are typical.
Specifications are subject to change without notice, due to advancements in technology.
ProTalk ® is a registered trademark of JVCKENWOOD Corporation in the
United States and other countries.
Model PKT-23
GENERAL
Frequency Range
451-470 MHz
BRS Preset 99 Channels
Number of Channels 4
Channel Spacing
(FCC Narrow Compliant) 12.5 kHz
Channel Step 5, 6.25 kHz
Operating Voltage 3.8V DC±10%
Battery Life (5-5-90 duty cycle)
with KNB-71L (1,430mAh) Approx. 11 hours (Battery saver off)
Approx. 15 hours (Battery saver on)
Operating Temperature Range* -14°F ~ +140°F (-10°C ~ +60°C)
Frequency Stability ±2.5ppm (-14°F ~ +140°F)
Antenna Impedance 50 Ω
Dimensions (W x H x D), Projections not Included
Radio with KNB-71L 1.8 x 3.3 x 0.8 in. (46.0 x 85.0 x 21.0 mm)
Weight (net)
Radio with KNB-71L 3.9 oz. (110 g )
FCC ID ALH460300
FCC Compliance Part 90
Model PKT-23
RECEIVER (Measurements made per TIA/EIA-603)
Sensitivity (12dB SINAD)
Narrow 0.22 µV
Selectivity
Narrow 60 dB
Intermodulation Distortion
Narrow 50 dB
Audio Output 300 mW with less than 5% distortion
TRANSMITTER (Measurements made per TIA/EIA-603)
RF Output Power
High 1.5 W (ERP)
Low 0.5 W (ERP)
Spurious Response 55 dB
Modulation
Narrow 11KØF3E
FM HUM & Noise
Narrow 50 dB
Audio Distortion Less than 5%
Specifications
All accessories and options may not be available in all markets.
Contact an authorized Kenwood dealer for details and complete list of all accessories and options.
Applicable MIL-STD & IP
Standard MIL 810C MIL 810D MIL 810E MIL 810F MIL 810G
Methods/Procedures Methods/Procedures Methods/Procedures Methods/Procedures Methods/Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II 500.5/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II 501.5/Procedure I, II
Low Temperature 502.1/Procedure I 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II 502.5/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II 503.5/Procedure I
Solar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I 505.5/Procedure I
Rain 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III 506.5/Procedure I, III
Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507.4 507.5/Procedure II
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4 509.5
Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III 510.5/Procedure I
Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I 514.6/Procedure I
Shock 516.2/Procedure I, II, V 516.3/Procedure I, IV 516.4/Procedure I, IV 516.5/Procedure I, IV 516.6/Procedure I, IV
International Protection Standard
Dust & Water Protection IP54
■ KNB-71L
Li-Ion Battery
(1,430 mAh)
■ KSC-44K
Fast Charger
and Power Supply
■ KHS-33
Earbud In-line
PTT Headset
(Single Pin Jack)
■ KHS-34
C-Ring In-line
PTT Headset
(Single Pin Jack)
■ KBH-20
Spring Action Belt Clip
■ KMB-44K
6 Radio Multi-Charger
*Based upon 5% transmit, 5% receive and 90% standby (standard duty cycle)