Kenwood TK-5410D - Manual (Page 2)

ADS#40913 Printed in USA
Model TK-5410D
GENERAL
Models
4-key w/LCD Model TK-5410DK2
Full key w/LCD Model TK-5410DK3
Frequency Range
Receive 763-776, 851-870 MHz
Transmit 763-776, 793-806, 806-825, 851-870 MHz
Number of Channels 1024
Zones 100
Max. Channels per Zone 512
Channel Spacing
Analog 12.5 / 25 KHz
Digital 12.5 kHz
PLL Channel Steps 12.5 kHz
Operating Voltage 7.5 VDC ± 20 %
Battery Life 5-5-90 (10-10-80) duty cycle
KNB-54N, 7.5 VDC, 2500 mAh 12 hours (8 hours)
KBP-6, AA Alkaline x6 Batteries (@ 1W) 8 hours (5 hours)
Operating Temperature Range -22˚ F to +140˚ F (-30° C to +60° C)
Frequency Stability ± 1.5 ppm (-22° F to +140° F)
Antenna Impedance 50 Ω
Dimensions (W x H x D) (projections not included)
with KNB-54N 2.28 x 6.10 x 1.80 in. (58 x 155 x 45.7 mm.)
with KBP-6 2.36 x 6.10 x 1.84 in. (60 x 155 x 46.7 mm.)
Weight (Radio only)
4-key w/LCD Model 11.64 oz. (330 g)
Full key w/LCD Model 11.64 oz. (330 g)
Weight w/Antenna & Belt Clip (4-Key w/LCD Model)
with KNB-54N 23.28 oz. (660 g)
FCC ID ALH468800
IC Certification 282D-468800
Model TK-5410D
RECEIVER
Sensitivity
Digital (5 % BER) 0.25 µV
Digital (1 % BER) 0.40 µV
Analog 12 dB SINAD 0.25 µV
Selectivity
Digital -60 dB
Analog @ 25 kHz -75 dB
Analog @ 12.5 kHz -64 dB
Intermodulation Distortion -75 dB
Spurious & Image -75 dB
Audio Distortion
Digital Less than 1.0 %
Analog Less than 2.0 %
Audio Output 500 mW / 8 Ω
TRANSMITTER
RF Power Output
3 W / 1 W
Spurious & Harmonics 70 dB
FM Hum & Noise
Analog @ 25 kHz 45 dB
Analog @ 12.5 kHz 40 dB
Audio Distortion Less than 2 %
Modulation Limiting
Analog @ 25 KHz ± 5 kHz
Analog @ NPSPAC ± 4 kHz
Analog @ 12.5 KHz ± 2.5 kHz
Modulation 16K0F3E, 11K0F3E, 8K10F1E,
8K10F1D, 8K10F1W, 14K0F3E
■ KNB-54N
Ni-MH Rechargeable
Battery Pack (2500 mAh)
■ KNB-33L
Li-ion Rechargeable
Battery Pack (2000 mAh)
■ KNB-43L
Li-Polymer Rechargeable
Battery Pack (3300 mAh)
■ KNB-49PL
Primary Lithium Non-Rechargeable
Battery (4500 mAh)
■ KBP-6
Battery Case
■ KSC-32
Tri-chemistry
Rapid Charger
■ KPG-93
KVL Device Key
Loader Cable
■ KRA-32
700/800 MHz
Whip Antenna
■ KMC-42WD
MIL-STD & IP54/55/67
Speaker Microphone
(Future Availability)
■ KMC-52WD
MIL-STD & IP54/55/67
Digital Noise-canceling
Speaker Microphone
(Future Availability)
■ VGS-1
Voice Guide
& Storage Unit
■ KSC-326
Rapid Rate Six Unit Charger
for Ni-Cd/Ni-MH/Li-Ion
■ KVC-18/20L
D.C. Vehicular Charger
KVC-18 (for Ni-Cd/Ni-MH)
KVC-20L (for Li-ion/Li-Polymer)
■ KEP-1
Heavy Duty Earphone
■ KHS-11
2-Wire Palm Mic
with Earphone
All accessories and options may not be available in all markets.
Contact an authorized Kenwood dealer for details and complete list of all accessories and options.
Windows ® is a registered trademark of Microsoft Corporation
in the United States and other countries.
AMBE+2™ is a trademark of Digital Voice Systems Inc.
The P25 Logo is used under license and is a registered
trademark of the Project 25 Technology Interest Group.
Specifications are subject to change without notice, due to advancements in technology.
Analog measurements made per TIA/EIA 603 and specifications shown are typical.
Digital measurements made per TIA/EIA 102CAAA and specifications shown are typical.
Options
Specifications
KNB-54N
*IP68: 3.3 feet (1m) depth @ 2 hours.
Applicable MIL-STD & IP
Standard MIL 810C MIL 810D MIL 810E MIL 810F MIL 810G
Methods/Procedures Methods/Procedures Methods/Procedures Methods/Procedures Methods/Procedures
Low Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, II 500.5/Procedure I, II
High Temperature 501.1/Procedure I, II 501.2/Procedure I, II 501.3/Procedure I, II 501.4/Procedure I, II 501.5/Procedure I, II
Low Temperature 502.1/Procedure I, II 502.2/Procedure I, II 502.3/Procedure I, II 502.4/Procedure I, II 502.5/Procedure I, II
Temperature Shock 503.1/Procedure I 503.2/Procedure I 503.3/Procedure I 503.4/Procedure I, II 503.5/Procedure I
Solar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure I 505.5/Procedure I
Rain 506.1/Procedure I, II 506.2/Procedure I, II 506.3/Procedure I, II 506.4/Procedure I, III 506.5/Procedure I, III
Humidity 507.1/Procedure I, II 507.2/Procedure II, III 507.3/Procedure II, III 507.4 507.5/Procedure II
Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4 509.5
Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, III 510.5/Procedure I
Vibration 514.2/Procedure VIII, X 514.3/Procedure I 514.4/Procedure I 514.5/Procedure I 514.6/Procedure I
Shock 516.2/Procedure I, II, V 516.3/Procedure I, IV 516.4/Procedure I, IV 516.5/Procedure I, IV 516.6/Procedure I, IV
Immersion 512.1/Procedure I 512.2/Procedure I 512.3/Procedure I 512.4/Procedure I 512.5/Procedure I
International Protection Standard
Dust & Water IP54/55
Dust & Water Jet Intrusion IP66
Immersion
IP67/68*