Kenwood TH-D72A - Manual (Page 49)

40
Concerning the received frequency display, an unmodulated signal may be
received. This is according to the set intrinsic frequency form.
<A band> <B band>
VxU reception
(144 MHz + 49.95 MHz) x 2 – (430 MHz - 45.05 MHz) = 45.05 MHz, 49.95 MHz
(144 MHz + 49.95 MHz) x 4 – (430 MHz - 45.05 MHz) x 2 = 45.05 MHz, 49.95 MHz
UxV reception
(430 MHz - 49.95 MHz) – (144 MHz + 45.05 MHz) x 2 = 45.05 MHz, 49.95 MHz
(430 MHz - 49.95 MHz) x 2 – (144 MHz + 45.05 MHz) x 4 = 45.05 MHz, 49.95 MHz
GPS setting: 16.369 MHz x n (n = multiple)
Problem Probable Cause Corrective Action
When using a GPS
receiver, you cannot
correctly transmit
position data. The GPS receiver did
not yet start correct
measurement. Before starting correct
measurement, the GPS
receiver generates a low-
pitch tone every 10 seconds.
When starting correct
measurement, it generates a
high-pitch tone. (If not using
the internal GPS receiver,
press [F], [MARK] and
select
“OFF” ).
You cannot receive any
APRS data. You did not correctly
program a group code. Access Menu 3S0 and
program
“ APK003 ” .
“MCP ERR” appears on
the display. (MCP-4A
communications error) 1 Loose cable
connection.
2 Your PC may be
trying to process too
much at once.
3 There are other
reasons as to why
communications was
not possible.
1 Ensure that the connection
between the TH-D72 and
the PC is correct.
2 Shut down other software
that you may be running.
3 Turn the TH-D72 power
source OFF and ON, one
time.