Kenwood RC-D710 - Manual (Page 8)

2
INSTALLATION
SEMS screw
(M4 x 10 mm)
Panel holder
Tapping screw
(4 mm x 12 mm)
Flat washer
Adhesive tape
Panel
bracket
■ Fixed Station
1 Attach the panel holder to the base
stand using the 2 supplied SEMS
screws.
2 Attach the RC-D710 to the panel
holder so that it locks in place.
SEMS screw (M4
x 10 mm)
Panel holder
Base stand
■ Mobile Installation
1 Clean and dry the installation location.
Do not install the bracket close to an air bag.
2 Remove the release paper from the base
of the panel bracket, then secure it in
place using the 3 supplied self-tapping
screws.
• Allow the panel to set for a while, to
ensure it remains fast. Otherwise,
vibrations may occur.
• After removing the release paper, it
cannot be reused.
3 Attach the panel holder to the panel
bracket using the 2 supplied SEMS
screws.
4 Attach the RC-D710 to the panel holder
so that it locks in place.