Kenwood TK-190 - Manual (Page 16)

11
• Channel Up: Press to increase the channel by 1 step.
Press and hold to continuously scroll through the
channels. Unprogrammed channels will be skipped.
Note: Your dealer can program the “Roll Over” (default) or
“Dead End” feature. When Roll Over is programmed, pressing
Channel Up while you are at the highest channel will cause the
transceiver to select the lowest channel, and begin the increase
cycle again. When Dead End is programmed, pressing Channel
Up while you are at the highest channel will not change the
channel number.
• Delete/Add: Press to remove an undesired channel
from the scan sequence or to add a desired channel to
the scan sequence. See “SCANNING” on page 16.
• Emergency Call: Press and hold this key for the time
required (which is pre-programmed by your dealer) to
enter Emergency mode. If “Emergency Channel
Display” is activated by your dealer, the emergency
channel name will appear on the display and the TX
LED (red) will light.
• Home Channel: Press to change from the current
channel to your home channel. Press again to return to
the previous channel, from your home channel.
• Invert Display: Press to invert both segmented
displays (the icons do not change). This allows channel
numbers, names, and other information to be easily
read when you use the transceiver in such a way as to
have the display upside down.
• Key Lock: Press to lock most of the keys on the
transceiver. Press again to unlock the keys. See “Key
Lock” on page 23.